stock #	20108
	Input	11-15V
	Charge Range	1-14NICAD 1-14NIMH    6-12V PB 1-5 Lipos
	Selectable charge current discharge	0.1-5A  100-500mA
	Automatic cut off	Charging time approx 0.5-2 hrs

             

NEW Features:

Easy  4 button programming  Clear flow chart and on screen display. What blinks can be changed with the up and down buttons.

2 line 16 character LCD display showing accumulated charge-or discharge, elapsed time, battery voltage input and output. Error messages.

  Charge 1-5 Lion or Lipo cells, 1-14 cell NiCad NIMH , 6-12 Volt PB batteries (Field box battery)

Safety timer programmable

Up to 5 discharge/charge cycles programmable 

 Automatic or manual charge till full

 Lithium Polymer batteries have a very critical charge cycle which has to be monitored by the charger sensors. The powerful Lithium cells may only be charged to a maximum of 4.2 Volts per cell. That means a 2 S battery would have a limit of 2 x 4.2 V = 8.4 Volts etc.

If the charger setting is wrong (too high), for example set to 3 cells instead of 2 cells,  the voltage would exceed the maximum level and a devastating process would start, which results in burning of the battery.

The X-Peak charger has a built-in safety device which would detect wrong programming and would give an error message.

If in doubt, charge batteries in ceramic or metal containers. After a crash or mid-air,  take the shrink tubing of the cells and check the wiring for blank spots which could touch or for contacts which could touch and short circuit.  Also check whether  the cells are punched. If the cells are damaged, take the battery apart and store cells separately from each other and dispose off bad cells. We are using our battery packs for over 14 months now and they are doing just fine.